10x Drken DELTA MultiBand M60 25 m

10 x Douml;rken DELTA MultiBand M60 25 m

Universal adhesive tape with maximum bonding strength

• High aging resistance
• Suitable for indoor and outdoor use

Suitable substrates for bonding:

• Smooth to slightly rough films made of PE polyethylene, PA polyamide, and aluminum composite films
• Surface-reinforced nonwovens made of PP polypropylene
• Kraft paper
• All DELTA films, each on the printed film surfaces

Suitable substrates for bonding:

• Planed wood
• Hard wood-based panels such as OSB/particle boards, possibly primed with DELTAHF PRIMER
• Hard plastics
• Metal
• Glass
• Porous and absorbent substrates such as softwood fiberboards must be pretreated with DELTAHF PRIMER / DELTAPREN before bonding to ensure good adhesion and high bonding strength

Processing:

• Films and substrates must be load-bearing, dry, frost-free, free of dust, dirt, grease, softeners, ice, and rime, and free of substances that repel adhesive bonding
• A trial bond on site is recommended
• The surface tension of the substrate should be at least 36 mN/m
• Bonded strips must be laid and fixed without tension or folds
• Overlaps must be seamless, i.e., fold-free and without defects, to be bonded
• The adhesive strength depends on storage, substrate, environmental conditions, and time
• The final strength develops within the functional range: 40 °C to 80 °C; processing range: 5 °C to 40 °C
• The adhesive tape should be stored at room temperature before processing; do not store at freezing temperatures
• The adhesive tape must be applied tension-free and without shear or foam stress on the substrates to be bonded. It must be ensured that no stresses occur after bonding, e.g., when installing battens under vapor barriers, to prevent tearing
• The best possible bonding can be achieved if the adhesive tape is rubbed with a pressure-distributing tool, e.g., a firm sponge
• The construction process should be coordinated so that humidity levels > 80 % RH during and after bonding are avoided
• Prolonged exposure to moisture must be avoided
• Do not bond on visible parts later, as the adhesive tape can no longer be removed
• The adhesive is not permanently UV resistant and must be covered and protected from UV light at the latest 6 months after application