12x Beko Fountain Foam 750ml

12x Beko Well Casing Foam 750ml

Single-component polyurethane foam

Waterproof up to 0.8 bar, 8 m water column, pressure resistance test report available, resistant to municipal wastewater, non-toxic in cured state, hygiene report, B2 quality, weather-resistant, frost-resistant
nbsp;
Processing advantages:
Replaces the need for pre-foaming, time-saving due to easy application, quick-hardening, high yield approx. 42 liters, fills cavities, simple and clean handling, with resealable foam nozzle, universally and safely applicable, paintable and overcoatable
nbsp;
Application areas:
Sealing of joint rings, cisterns, house drain systems, filling and sealing of wall penetrations, sealing of wall anchors and house connections, universally applicable for moisture sealing

nbsp;

nbsp;

nbsp;

nbsp;

nbsp;

nbsp;

Safety Data Sheet
Data sheet	Safety Data Sheet PDF
Revised by supplier on	29052015
Transport Data
UN Number	1950
Substance designation	PRESSURE GAS PACKAGES, flammable
Hazard label	21
Transport category	2
Evaluation factor	3
Extended Transport Data
Tunnel code	D
Limited Quantity	1 L
Expected Quantity	EQ0
Dangerous goods unit	8 bottles
Design-verified ME	dos
Occupational Safety and Storage
GHS hazard statements	H222 Extremely flammable aerosol H229 Pressurized container: may burst if heated H315 Causes skin irritation H317 May cause allergic skin reactions H319 Causes serious eye irritation H332 Harmful if inhaled H334 May cause allergy, asthma-like symptoms or breathing difficulties if inhaled H335 May irritate respiratory system H351 Suspected of causing cancer; specify route of exposure if conclusively proven that this hazard exists only via a specific route H373 May damage organs through prolonged or repeated exposure; specify route of exposure if conclusively proven that this hazard exists only via a specific route
Precautions	Please observe section 22 of the safety data sheet P102 Keep out of reach of children P210 Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking P211 Do not spray against open flame or other ignition sources P251 Do not pierce or burn, even after use P261 Avoid inhalation of dust/fume/gas/mist/vapor/aerosol P280 Wear protective gloves/protective clothing/eye protection/face protection P305P351P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing P410P412 Protect from sunlight and do not expose to temperatures exceeding 50°C/122°F P501 Dispose of contents/container in accordance with local/regional/national/international regulations
Storage classes	2B Pressure gas packages, aerosol cans/spray cans
Water hazard class	1 slightly water hazardous
Hazards
Signal word	Danger
GHS pictograms
Ingredients
CAS Number Basis of Entry Substance Name 9016879 nbsp; nbsp; 13674845 nbsp; nbsp; 115106 nbsp; nbsp; 74986 nbsp; nbsp; 75285 nbsp; nbsp;

nbsp;

nbsp;

nbsp;

nbsp;

Notes on the return obligation for packaging material

We are obliged under the current Packaging Act according to section 15 paragraph 1 sentence 1 VerpackG to take back the following packaging materials free of charge from end consumers:

• Transport packaging, such as pallets, large packaging, etc.,
• Sales and secondary packaging that typically do not become waste from private end users after use,
• Sales and secondary packaging for which, due to system incompatibility according to section 7 paragraph 5, a system participation is not possible, and
• Sales packaging containing hazardous substances or
• Reusable packaging

When delivering the product, the appropriate packaging material is used, which we take back free of charge. This ensures the return of packaging material into the recycling cycle. By informing about return options, better results can be achieved in the return of packaging and a contribution to fulfilling the European recycling targets according to Directive 94/62/EC is ensured.

You as an end consumer can hand in the packaging material at the place of actual transfer or in its immediate vicinity.

If an environmentally and health-compatible return of hazardous substances in sales packaging, as well as for sales and secondary packaging for which, due to system incompatibility according to section 7 paragraph 5, a system participation is not possible, at the place of actual transfer or in its immediate vicinity is not feasible, the return can also be made at a central collection point according to section 15 paragraph 2 VerpackG, provided that this is at a reasonable distance from the place of actual transfer and accessible during the usual business hours of the distributor.