Drken DELTA MultiBand M60 25 m

Douml;rken DELTA MultiBand M60 25 m

Universal adhesive tape with the highest bonding strength

• Highly weather-resistant
• Suitable for indoor and outdoor use

Suitable substrates for bonding:

• Smooth to slightly rough films made of PE polyethylene, PA polyamide, and aluminum composite films
• Surface-reinforced nonwoven fabrics made of PP polypropylene
• Kraft paper
• All DELTA films, each on the printed film surfaces

Suitable substrates for bonding:

• Planed wood
• Hardwood-based panels such as OSB/particle boards, possibly primed with DELTAHF PRIMER
• Hard plastics
• Metal
• Glass
• Porous and absorbent substrates such as wood fiberboards must be pretreated with DELTAHF PRIMER / DELTAPREN before bonding to achieve a good adhesive surface and ensure high adhesion

Processing:

• Films and substrates must be load-bearing, dry, frost-free, free of dust, dirt, grease, softeners, ice, and frost, and free of substances that repel adhesive
• A trial bonding on site is recommended
• The surface tension of the substrate should be at least 36 mN/m
• Bonding tapes must be laid and fixed without tension, folds, or creases
• Overlaps must be seamless, i.e., free of folds and defects, and bonded
• The adhesive strength depends on storage, substrate, environmental conditions, and time
• The final strength develops within the functional range: 40°C to 80°C; processing range: 5°C to 40°C
• The adhesive tape should be stored at room temperature before processing; do not store at freezing temperatures
• The adhesive tape must be applied tension-free and without shear or foam stress on the substrates to be bonded. It must be ensured that no stresses occur after bonding, e.g., when installing battens under vapor barriers, to prevent tearing
• The best possible bonding can be achieved if the adhesive tape is rubbed with a pressure-distributing tool, e.g., a firm sponge
• The construction process should be coordinated to avoid humidity levels > 80 % rF during and after bonding
• Prolonged exposure to moisture must be avoided
• Do not bond on parts that are visible later, as the adhesive tape can no longer be removed
• The adhesive is not permanently UV-resistant and must be covered and protected from UV light at the latest 6 months after application