PCI Carrafug Joint Mortar 5kg

PCI Carrafug Special Joint Mortar for Natural Stone Slabs

Product Features

• Crack-free, durable joint filler that does not shrink or crack out
• Fast setting, easy to wash out, and walkable after approximately 6 hours, enabling efficient work processes
• Waterproof and frost-resistant, suitable for indoor and outdoor use
• Widely temperature-independent expansion profile, with the same washout time at low and high temperatures
• Does not cause edge zone discoloration on sensitive natural stones
• High joint filling degree
• Temperature resistant from -20°C to +80°C
• EMICODE EC 1 PLUS

Colors

• No. 22 Sand Gray
• No. 25 Carrara White
• No. 26 Pearl Gray
• No. 27 Jura Beige
• No. 47 Anthracite

Delivery Forms

• 5 kg bag

Application Area

• For indoor and outdoor use
• For walls and floors
• For heated screeds, balconies, and terraces
• For grouting natural stone slabs such as marble, travertine, granite, Solnhofen slabs, etc.
• For joint widths from 1 to 8 mm

Substrate Preparation

Immediately after laying the slabs, scrape and clean the joints evenly to a depth corresponding to the slab thickness. Allow the adhesive or laying mortar to cure. Do not pre-wet joints before grouting.

Processing of PCI Carrafug

Mix water in a clean container, then add PCI Carrafug and stir with a suitable drill or mixing tool attached to a drill until a homogeneous, lump-free mortar is achieved. After approximately 3 minutes, stir again.

Grouting of the surfaces

Apply PCI Carrafug in a continuous layer into the joint using a rubber float on floors or a suitable spatula on walls. After sufficient setting, wipe off with a slightly damp sponge or sponge board. Remove any remaining mortar residue after drying with a damp sponge.

Safety Data Sheet

Hazards

Signal word	Danger
GHS Pictogram
GHS Pictogram

Ingredients