ACTION - PCI Carrafug paving joint mortar No.22 sand grey 5kg MHD:10/25

PCI Carrafug special jointing mortar for natural stone slabs

Shelf life: 10/2025. Goods from returns and warranty excluded.

Product features:

• Cures crack-free; the joint does not crack or crumble.
• Sets quickly, can be washed off quickly and is already walkable after approx. 6 hours, enabling efficient work.
• Water-resistant and frost-resistant, suitable for use both indoors and outdoors.
• Hardening profile largely independent of temperature; at both low and high temperatures, the washing-off time remains approximately the same.
• Does not cause edge-zone discolouration on sensitive natural stone.
• High joint-filling grade.
• Temperature-resistant from - 20 °C to + 80 °C.
• EMICODE: EC 1 PLUS R

Colours: No. 22 sand grey, No. 25 carrara white, No. 26 pearl grey, No. 27 jurabeige, No. 47 anthracite´

Pack sizes: 5-kg bags

Application area:

• For indoor and outdoor use.
• For walls and floors.
• For heated screeds, balconies and terraces.
• For jointing natural stone slabs such as marble, travertine, granite, Solnhofen slabs etc.
• For joint widths of 1 to 8 mm.

Substrate preparation:
Scratch out the joints evenly to the slab thickness immediately after setting the slabs and clean. Allow setting or laying mortar to harden. Do not pre-wet the joints before jointing.

Application of PCI Carrafug:
Fill mixing water into a clean working vessel. Then add PCI Carrafug and mix to a plastic, lump-free mortar using a suitable mixing or stirring tool as an attachment on a drill.
After a maturation time of approx. 3 minutes, remix again.
Jointing of the coverings
Apply PCI Carrafug in wall and floor areas using a PCI rubber jointing disc; in floor areas also use a rubber squeegee. Work the jointing mortar flush into the joint and, after sufficient setting (finger test), rub off with a slightly damp sponge or sponge board.
After drying, remove the remaining mortar film with a damp sponge.

Safety data sheet
Data sheet	Safety data sheet.pdf
Revised by the supplier on	05.07.2016
Gefkommlink
Occupational safety and storage
H statements - GHS	H315 Causes skin irritation. H318 Causes serious eye damage. H335 May cause respiratory irritation.
P statements	Please refer to section 2.2 of the safety data sheet P102 Keep out of the reach of children. P261 Avoid breathing dust/fume/gas/mist/vapours/aerosol. P264 Wash thoroughly after use …. P280 Wear protective gloves/protective clothing/eye protection/face protection. P302+P352 IF ON SKIN: Wash with plenty of water/…. P304+P340 IF INHALED: Remove the person to fresh air and keep comfortable for breathing. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P315 Get immediate medical advice/attention. P332+P313 If skin irritation occurs: Get medical advice/attention. P362+P34
Storage classes	13 Non-combustible solids
Water hazard class	1 - slightly water hazardous
Hazards
Signal word	Danger
GHS pictograms
Ingredients
CAS number Reason for inclusion Substance name 1305-62-0 65997-15-1