Beko Allcon 10 Construction Adhesive with High Bond Strength including 1 Pair of Disposable Gloves
Weather-resistant according to DIN EN 204 D4. Test report available. Bonds nearly all materials in a one-component system. Easy handling, solvent-free, silicone-free, weather-resistant, resistant to many chemicals, frost-proof, high final strength, suitable for natural stone.
Processing advantages
- Processing with common cartridge guns, ready for load after approximately 7 to 10 minutes, replaces many other adhesives and glues, always have the right product on hand, safety in application.
- Opened cartridge lasts about 10 months, unopened about 18 months.
- Good dosing, paintable and overcoatable, suitable for indoor and outdoor use.
Application areas
Bonding of wood, chipboard, fiberboard, MDF, coated panels, metals, aluminum, natural and artificial stone, concrete, marble, ceramics, plastics, plasterboards, foam, EPS, hard foam, acrylic, insulation materials, and much more.
Approximate joint width: 3 mm. Allcon10, 24 hours curing time for surface bonding, bonds to approximately 70% after 7-10 minutes, and 100% after 30-45 minutes.
Base: Polyurethane, moisture-curing. Tested, test report according to DIN EN 204 D4, water-resistant bonding according to WATT 91 80°C. Odor: Low odor. Durability in opened state: about 10 months, unopened: about 1.5 years. Skin formation time: approx. 3 minutes at normal climate. Storage: dry at room temperature. Gap bridging: approx. 10 cm. Temperature resistant from -40°C to 80°C, short-term up to 120°C. Processable from 5°C to max. 40°C. Viscosity: paste.
Important notice
Persons already sensitized to diisocyanates should handle this product with caution as allergic reactions may occur. Avoid skin contact with the product if you have asthma, eczema, or skin problems.
Do not use the product in poorly ventilated areas or wear a gas filter mask of type A1 according to EN 14387.
Warning
Keep out of reach of children.
| Safety Data Sheet | |
|---|---|
| Safety Data Sheet PDF | |
| 28.07.2014 |
Occupational safety and storage
EUH204 Contains isocyanates. May cause allergic reactions. | |
H315 Causes skin irritation. | |
H317 May cause allergic skin reactions. | |
H319 Causes serious eye irritation. | |
H334 May cause allergy or asthma symptoms or breathing difficulties if inhaled. | |
H335 May cause respiratory irritation. | |
H351 Suspected of causing cancer. Provide the route of exposure if it is conclusively proven that this hazard exists via a specific exposure pathway. | |
H373 May cause damage to organs through prolonged or repeated exposure. Specify affected organs and route of exposure if conclusively proven that this hazard exists via a specific exposure pathway. |
P101 If medical advice is needed, keep the container or label available. |
P102 Keep out of reach of children. |
P202 Read all safety instructions before use. |
P260 Do not breathe dust, fumes, gas, mist, spray, or aerosol. |
P264 Wash thoroughly after handling. |
P271 Use only outdoors or in a well-ventilated area. |
P272 Contaminated work clothing should not be removed from the workplace. |
P280 Wear protective gloves, protective clothing, eye protection, and face protection. |
P284 In case of insufficient ventilation, wear respiratory protection. |
P303/P352 IF ON SKIN: Wash with plenty of soap and water. |
P304/P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing. |
P304/P341/P311 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing. |
P305/P351/P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing. |
P308/P311 If exposed or concerned: Call a poison center or doctor. |
P332/P313 If skin irritation occurs: Get medical advice. |
P333/P311 If skin irritation or rash occurs: Get medical advice. |
P362/P364 Take off contaminated clothing and wash before reuse. |
P403/P233 Store in a well-ventilated place. Keep container tightly closed. |
P405 Store locked up. |
P501 Dispose of contents/container in accordance with local regulations. |
Lagerklassen
Flammable liquids, flash point > 60°C
Wassergefährdungsklasse
1 - Slightly water hazardous
Gefahren
| Gefahr | |
 | Health hazard |
Inhaltsstoffe
| CAS-Nummer | Aufnahmegrund | Stoffname |
|---|---|---|
| 9016879 | n-Butylacetat | |
| 101688 | Isocyanate | |
| 6425394 | Polyurethan | |
| 5873541 | Polymer | |
| 2536052 | Acrylate |
- Item weight: 5,50 kg
- Content: 3,10 l
- GoogleShopping: Hauptsortiment
