PCI Gisogrund 404 SpezialHaftgrundierung 5 L Eimer

PCI Gisogrund 404 Special Adhesion Primer for Absorbent and Non-Absorbent Substrates

Product Properties

• Low-emission according to TRGS 610 Giscode D 1
• Very low emissions PLUS GEV EMICODE EC 1 PLUS
• EU 200442IIAg5030, less than 7 g/l
• Adjustable water dilution based on the absorbency of the substrate
• High bond strength ensures secure adhesion of coverings and screeds to the respective substrate
• Control color violet for good surface control
• EMICODE EC 1 PLUS

Color: violet

Delivery Forms: 20l bucket, 5l bucket, 1l stand-up pouch

Application Area

• For interior and exterior use
• On absorbent and weakly absorbent concrete and screed substrates
• As a special primer for PCI Zemtec 1K, PCI Zemtec 180, PCI Periplan, PCI Periplan Extra, PCI Periplan Plus, PCI Periplan Fein, PCI Periplan Multi, and PCI Periplan White
• As a special primer on anhydrite, cast asphalt, and magnesite screeds for leveling compounds and tile adhesives
• As a special primer on wooden floors, chipboard, and OSB panels
• As a special primer on non-absorbent substrates such as ceramic tiles for subsequent leveling compounds and tile adhesives
• Suitable for use on ships, meeting the requirements of the Marine Equipment Directive MED 9698EC

Substrate Preparation

The substrate must be firm, clean, dry, free of oil, and free of separating substances. The surface condition must meet the requirements of the subsequent coverings.

Application of PCI Gisogrund 404

Thoroughly stir PCI Gisogrund 404. Apply the primer evenly using a fine-pored foam roller, brush, soft-haired broom, or mop on the cleaned and pretreated substrate, and saturate with a cross-coat to avoid puddling. A second coat can be applied after the first coat is walkable. For spray application, use a particle filter mask P2.

For cement and magnesite screeds, dilute PCI Gisogrund 404 1:3 with water and apply in two coats until saturated. For concrete substrates, dilute 1:2 with water and apply in two coats until saturated. For anhydrite, cast asphalt, and magnesite screeds, dilute 1:1 with water and apply once until saturated. For untreated raw wooden floors and chipboard, a second coat is necessary after walkability is achieved. Old ceramic and natural stone coverings should be primed once with PCI Gisogrund 404 undiluted.

After the hardened primer, subsequent leveling compounds and tile adhesives can be applied for laying ceramic coverings. On anhydrite substrates, a waiting time of 12 hours must be observed.

Safety Data Sheet