Palette tubag Pflasterfugenmörtel PFF Palettenware

tubag Joint Mortar PFF

Ready-to-use, water-permeable joint mortar for paving, natural stone slabs, and clinker paving. Suitable for classic pointing applications. Easy and efficient processing through Easy Clean Technology. For usage class N1 according to ZTV Wegebaubr.

Properties

• Ready-to-use, pre-mixed
• Loosely breathable
• Water-permeable
• Applied by traditional pointing methods
• Simple and efficient processing via Easy Clean Technology
• Effectively prevents plant growth in joints
• Frost-resistant
• Suitable for sweepers

Application

• Suitable for usage category N1 according to ZTV Wegebau
• For new paving and repair of paving, natural stone slabs, and clinker paving
• For gardens and park areas, walkways, and surfaces with predominantly foot traffic

Quality & Safety

• Quality monitored
• Mineral additives
• Substrate

The paving surfaces and the corresponding substructure must be constructed so that no loosening of the surface occurs under later loads. The relevant regulations and information sheets for the manufacture of paving surfaces must be observed. The entire structure must be water-permeable to allow infiltrating water to drain away. The minimum joint width for pointing with the pointing mortar is 3 mm. The minimum joint depth is 30 mm. An exception applies to ceramic and fine stoneware terrace slabs laid in bonded construction, where the minimum joint depth is approximately 20 mm. The stone edges must be free of all types of contamination. Before applying the mortar, the surface must be thoroughly pre-wetted. No water may stand in the joints.

Processing

The mortar is pre-mixed and ready to use. Cut open the vacuum plastic bag and pour onto the well-prewetted paving surface. To minimize the risk of staining, it is recommended to point the joints with PFF joint mortar using plenty of water. Sweep off remaining mortar residues on the surface with a soft broom diagonally to the joint direction. When using pavers or slabs with beveled edges, the joint must only be filled up to the underside of the bevel after cleaning. The paving must not fully dry out until the surface is completely cleaned. The surface must be carefully swept free of mortar residues, as unremoved components can be fixed by the adhesive upon heating and can only be cleaned mechanically afterwards. Residual gloss effects on the surface may fade over time. For particularly light and open-pored stone types, the binder may cause effects such as darkening. It is recommended to create a test surface with the selected paving. Over time, color changes may occur due to dirt and weathering. When temperatures exceed 30°C or in strong wind, special measures such as shading should be taken.

Post-treatment

The freshly jointed surface should be protected from frost for 24 hours after processing. Heavy rainfall can wash out the joints in the fresh state. Therefore, cover the surface with a sheet if necessary. When using a protective sheet, ensure adequate ventilation. Do not place the sheet directly on the paving.

Load capacity

The paving surface can be walked on after approximately 24-48 hours depending on air temperature and can be fully loaded after about 7 days. These timeframes refer to processing at normal temperatures of 20°C and 65% relative humidity.

Consumption

Storage

Store dry, frost-free, and properly in the original packaging.

Safety Data Sheet