42x KNAUF SM700 Pro Adhesive Mortar White 1.0mm 25kg

42 Sack Knauf SM 700 Pro Adhesive and Reinforcement Mortar for Renovation or Bonding Mortar, each 25kg

System-tested, mineral, universal all-rounder for facade and base

The Knauf SM700 Pro is particularly suitable for bonding and reinforcing all Knauf WARMWAND systems

The special fiber reinforcement provides maximum security. Knauf SM700 Pro can be finished as a natural white or pigmented top coat, felted or freely textured. It is also well suited as a universal renovation mortar for reworking plasters and facades. For special highlights on the facade, Knauf SM700 Pro can also be applied using broom finish or combing techniques.

Features:

• Compressive strength class CS III according to DIN EN 998-1
• Fiber and adhesion additive
• Very high water repellency
• Very high bonding strength
• Diffusion-open
• Suitable for interior and exterior

• Grain size 1.0 mm
• Color tone white, approx. RAL 9001
• Pre-mixed, tintable according to Knauf ColorConcept
• Machine application or hand application

Application area:
System-tested, mineral, universal all-rounder for facade and base. SM700 Pro is particularly suitable for bonding and reinforcing all Knauf WARMWAND systems. The special fiber reinforcement provides maximum security. SM700 Pro can be finished as a natural white or pigmented top coat, felted or freely textured. It is also well suited as a universal renovation mortar for reworking plasters and facades.

• System-tested adhesive and reinforcement mortar for thermal insulation composite systems
• Renovation mortar for reworking
• Plaster bonding bridges
• Feltable and freely textured top coat
• Natural white or pigmented

Execution:
Adhesive mortar: Insulation boards should be pressed immediately, at the latest after 10 minutes, into the fresh adhesive bed. Allow a minimum stand time of 48 hours before further processing.
Reinforcement mortar: Embed reinforcement mesh fully, overlapping at the edges by at least 100 mm, wet-on-wet, close to the surface, in the outer third of the reinforcement layer. The reinforcement mesh must be completely covered by SM700 Pro. Layer thickness of the reinforcement layer on thermal insulation composite systems: 5-7 mm, on base coats: approx. 4 mm.
Renovation mortar: To compensate for surface irregularities, SM700 Pro can be applied in a layer thickness of up to a maximum of 10 mm. Embed reinforcement mesh as needed.
Top coat: For felted and freely textured surfaces, apply SM700 Pro in a layer thickness of 2-3 mm after a curing period of 12 days on the reinforcement layer already finished with SM700 Pro. When stiffening, felt or freely texture as desired.

Safety Data Sheet
Data sheet	Safety Data Sheet PDF
Revised by supplier on	28042015
Occupational safety and storage
GHS hazard statements	H315 Causes skin irritation H318 Causes serious eye damage
P statements	Please refer to section 22 of the safety data sheet P102 Keep out of reach of children P280 Wear protective gloves/protective clothing/eye protection/face protection P302P352 IF ON SKIN: Wash with plenty of water P305P351P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing. P310 Immediately call a POISON CENTER or doctor P501 Dispose of contents/container in accordance with local/regional/national regulations
Storage classes	13 Non-combustible solids
Water hazard class	1 slightly water hazardous
Hazards
Signal word	Danger
GHS pictograms
Ingredients
CAS Number Basis of inclusion Substance name 65997151 1305620