KNAUF Insulation Tape LDS Solifit S 60mm x 25m

KNAUF Insulation Klebeband LDS Solifit S 60mmx25m

Description
Reinforced adhesive tape based on HDPE for elastic sealing of vapor barrier membranes and air tightness layers in the area of penetrations according to DIN 4108 Part 7, SIA 180, ÖNORM B 81102, EnEV, and ETAG 007, as well as for connection bonding on suitable substrates. Part of the Knauf Insulation airtight sealing system, which is certified for its long-term function and aging resistance.

Advantages

• Quick and permanent airtight bonding of overlaps and penetrations indoors
• Fast processing without peeling off, collecting, or disposing of release paper
• Easy handling with finger lift and tearability by hand
• Suitable for pre-fixing vapor barrier membranes on rafters
• Free of solvents

Product Description
Reinforced adhesive tape based on LDPE for permanently elastic and airtight bonding of vapor barrier membranes and air tightness layers in the area of overlaps and penetrations according to DIN 4108 Part 7, SIA 180, ÖNORM B 81102, EnEV, and ETAG 007, as well as for connection bonding on suitable substrates. Part of the Knauf Insulation airtight sealing system, which is certified for its long-term function and aging resistance.

Aging Resistance of the Bonds
Properly bonded joints with certified system components are highly aging resistant, with a durability of over 50 years (test report from the University of Kassel). They thus meet the requirements of ETAG 007 guidelines for European technical approval and for building envelope sealing for timber frame construction.

Suitable Substrates

• LDPE vapor barrier membranes
• Polyamide and aluminum foils, as well as polyethylene foils according to DIN EN 13984
• Polypropylene spunbond membranes according to DIN EN 13984 and DIN EN 13859
• Kraft paper, wood-based panels with a solid surface, e.g., OSB panels made of long, flat oriented strands according to DIN EN 300
• Corrosion-resistant metal substrates
• Planed wooden components
• PVC and PE components
• Bonding on gypsum board and fiber-reinforced gypsum panels
• Wood-based materials and wood fiber panels, as well as rough-sawn timber components, should be primed before bonding

Please observe the valid processing guidelines.

Substrate Condition Notice
The bonding substrate must be load-bearing, dry, clean, free of sand, dust, grease, and silicone. Non-certified substrates must be checked for their suitability for bonding before work begins. If frozen or thawed substrates are present, bonding is not possible. Outgassing, separating, lubricating, and flame-retardant surfaces, as well as foil surfaces, can reduce the aging resistance of the bond.

For airtight sealing of joints and penetrations where a flexible connection is necessary (e.g., pipes, beams, etc.), the transparent liner must be removed beforehand.