weberdur 100 Mineral Dry Mortar for Primer Treatment 30kg
Application Area
weberdur 100 is a mineral dry mortar suitable for exterior and interior use for primer treatment of masonry, compressive strength class > 6 N/mm², lightweight wood wool panels, and similar substrates.
Product Properties
- Provides good mechanical adhesion for subsequent plaster layers due to the coarse aggregate
- Equalizes the absorbency of the substrate
Substrate Preparation
The substrate must be load-bearing, dry, and free of dust and substances that reduce adhesion.
Dry masonry may need to be pre-wetted.
For unsuitable substrates, e.g., deviations from DIN 1053 masonry or DIN 18202 tolerances in high-rise construction, concerns must be addressed, and remedial action taken.
Application
By machine: The mortar can be processed with all common plastering machines (see equipment planner).
By hand: Thoroughly mix the contents of a bag with the specified amount of water until a workable consistency is achieved.
Variant 1: The plaster is applied in a scratch coat, with the substrate still visible.
Variant 2: The plaster is applied fully covering, with the substrate no longer visible.
After setting, roughen the surface, e.g., with a broom.
Product Details
- Grain size approx. 3 mm
- Color shades: natural gray
- Water requirement: approx. 5 l per 30 kg
Storage
Stored in a dry, moisture-protected environment, the material remains storable for up to 1 year.
General Notes
- The mortar must not contain any additives.
- During processing and drying, the air temperature of the materials and substrate must not fall below 5°C.
- Fresh plaster surfaces should be protected from direct sunlight, strong wind, and moisture.
- Application and execution according to DIN 18 350 VOB/C and DIN 18 550.
- Consumption figures refer to minimum layer thickness and may vary depending on substrate and processing. Exact consumption values should be determined through trial applications on the site.
- Adjacent components must be separated from the plaster system.
- Sinter skin should be removed before applying additional layers.
Safety Data Sheet
| Safety Data Sheet | |
|---|---|
| Safety Data Sheet PDF | |
| GHS Safety Data Sheet PDF | |
| Revised by supplier on | |
| 05.01.2015 | |
Occupational Safety and Storage
Workplace Safety | |
| Hazard statement | H315 Causes skin irritation H318 Causes serious eye damage H335 May cause respiratory irritation |
| Precautionary statements | P101 If medical advice is needed, have product container or label at hand P102 Keep out of reach of children P103 Read label before use P280 Wear protective gloves, protective clothing, eye protection, face protection P302+P352 IF ON SKIN: Wash with plenty of water P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing. P310 Immediately call a poison center or doctor P362 Remove contaminated clothing P501 Dispose of contents/container in accordance with local regulations |
Storage Classes | |
| Non-combustible solid | Water hazard class: 1 (slightly water hazardous) |
Hazard Symbols
 |  |
Ingredients
| Chemical Name | CAS Number | Intake Route | Substance Name | |
|---|---|---|---|---|
| 65997151 | ||||
| 1305620 | ||||
- Color: Natural greyBottle
- Container: Bag2-3 hours
- Surface weight: Bright aluminum
- Grains: 3 mm
- Standing height: 4-6 hours
- Clothing size: P III
- Item weight: 30,00 kg
- Content: 30,00 kg
- GoogleShopping: Hauptsortiment
